×

Error

Kunena Internal Error: Please contact the site administrator to fix this issue!

Together with international partners, researchers at Graz University of Technology have developed a measurement method that measures particles below 10 nanometres for the first time and will contribute to the implementation of future, stricter emission standards. A few days ago, the European Commission presented its Green Deal, which aims to make the EU climate neutral by 2050 in order to protect the environment and improve people's health and quality of life. One of the planned measures is the introduction of stricter exhaust regulations. The limit values for pollutant emissions from vehicles have already been laid down by law.

 

The current target value is 6x1011 particles per kilometre (Euro 6d-Temp), but only particulate matter bigger than 23 nanometres (nm) is regulated. Smaller nanoparticles, such as those emitted by new and future generations of combustion engines in even greater numbers, cannot currently be detected in exhaust emission tests. However, this fine dust is even more harmful to health since particles of this size can penetrate unhindered into the lungs.

 

The measuring device can help automotive manufacturers reduce vehicle emissions by developing new combustion engines or by exhaust after-treatment. © BainschabThe measuring device can help automotive manufacturers reduce vehicle emissions by developing new combustion engines or by exhaust after-treatment. © Bainschab

 

 

Reliable measurement of ultrafine particles

As part of the Horizon2020 project "DownToTen", researchers from TU Graz and an international consortium have now developed a new method by which particles down to a size of 10 nm can be measured for the first time. Tests on the chassis dynamometer of TU Graz’s Institute of Internal Combustion Engines and Thermodynamics confirm the robustness of the process, as do tests in practical driving operation (Real Driving Emissions – RDE).

Markus Bainschab, a researcher at TU Graz’s Institute of Electronic Sensor Systems who is also in charge of the development of the new measuring system explains why such small particles were not able to be measured: “At the sub-23 nm scale, there are many liquid particles in the exhaust gas. These volatile droplets are not as dangerous to health as the solid particles. For an exact test result, we have to ensure that liquid particles are not detected by mistake during measurement. Using current measuring methods it is qualitatively not possible to remove the liquid particles without losing a large part of the solid particles. But we have succeeded in doing this through an optimized dilution system and the oxidation of hydrocarbons with the aid of a catalyst.”

 

Better understanding of the effects of exhaust gases on air pollution

The heart of the process is a mobile emission measuring device that is attached to the vehicle exhaust pipe and measures both new and old ultrafine particles. The detection of new and old particles has two advantages, as Bainschab explains: “In combination with an aerosol mass spectrometer, the ratio of vehicle emissions to old particles can be examined and it can be determined whether these so-called secondary aerosols are produced by the pollutant emissions.” These secondary aerosols do not necessarily have to be vehicle particles. Atmospherically aged particles can also originate from the sea, agriculture, forests or natural processes.

In the process, the newly produced emissions of the car are first recorded, then artificially aged in the atmosphere and analysed. The data are then compared with those of the measured secondary aerosols from the air. The result shows the real influence of car exhaust gases on air quality.

The process provides a better understanding of the formation of secondary aerosols by car exhaust gases and can help automotive manufacturers reduce vehicle emissions by developing new combustion engines or by exhaust after-treatment. In addition, the successful research can serve as a basis for new exhaust gas legislation.

The research project "DownToTen" is anchored in the Fields of Expertise "Mobility & Production" and "Sustainable Systems", two of the five strategic focal areas of TU Graz. The project has received funding from the European Union’s Horizon 2020 research and innovation programme under grant agreement Nr. 724085.

Project partner:
- TU Graz, Institute of Electronic Sensor Systems (Austria)
- TU Graz, Institute of Internal Combustion Engines and Thermodynamics (Austria)
- Aristotle University of Thessaloniki, Laboratory of Applied Thermodynamics (Griechenland)
- AVL List GmbH (Austria)
- Centro Ricerche FIAT S.C.P.A. (Italy)
- Ricardo plc (Great Britain)
- European Commission – Joint Research Centre (Italy)
- Tampere higher education community, Tampere University Tampere University of Applied Sciences (Finland)
- Technical University of Munich (Germany)

 

 

 
Contact for scientific information:

Markus BAINSCHAB
Dipl.-Ing. BSc
TU Graz | Institute of Electronic Sensor Systems
Inffeldgasse 10/II, 8010 Graz
Tel.: +43 316 873 3349
This email address is being protected from spambots. You need JavaScript enabled to view it.
ies.tugraz.at

 

 
 
Further information:

http://www.downtoten.com/ (Project Website)
https://ec.europa.eu/programmes/horizon2020/en (European Union’s Horizon 2020 research and innovation programme)
https://www.tugraz.at/forschung/forschungsschwerpunkte-5-fields-of-expertise/mob... (Info on FoE Mobility & Production)
https://www.tugraz.at/forschung/forschungsschwerpunkte-5-fields-of-expertise/sus... (Info on FoE Sustainable Systems)

 

 

 

Log in to comment